Correction to “Investigating the Potential of Electroless Nickel Plating for Fabricating Ultra-Porous Metal-Based Lattice Structures Using PolyHIPE Templates” Authors: Nihan Sengokmen-Ozsoz, R Boston, Frederik Claeyssens Published: 2023 In our original paper, we mistakenly put in the wrong printing parameters in Table 2 on page 30771. In the corrected Table 2 below, we present the correct printing parameters. This correction does not alter any of the conclusions of the paper. Table 23D Printing Parameters Used to Produce Discs and Lattices Exposure time (sec) Layer height (μm)Bottom layer countDiscLatticeBottom exposure time (sec)Transition layer countBottom lift distance/Lifting distance (mm)3051084055Bottom lift speed(mm/min)Lifting speed (mm/min)Bottom retract speed/Retract speed (mm/min)Rest time before/after lift (sec)Rest time after retract (sec)60705000.5 3D Printing Parameters Used to Produce Discs and Lattices