Radiative cooling effects on black hole hot accretion flows around the sub-Bondi radius

Mu-Qing Liu, Xiao-Hong Yang, De-Fu Bu · 2026

Read Radiative cooling effects on black hole hot accretion flows around the sub-Bondi radius by Mu-Qing Liu, Xiao-Hong Yang, De-Fu Bu (2026) in the Tower of Babel, a free online library of public-domain works preserved in clean, searchable text. No sign-up. The full text is served as a plain-text file at a predictable URL, where text is present: https://antarctic-labs.com/tower-of-babel/arxiv-2604-13762.txt.

Introduction

Liu, Yang, and Bu simulate winds in hot flows feeding a black hole, just inside the Bondi radius, and ask how radiative cooling changes them. As the accretion rate rises, cooling strengthens and thins the disk. Within the disk, the convectively stable region covers roughly 55 to 62 percent, so flows sit marginally stable. With weak cooling, winds drive the inward drop in inflow rate. With strong cooling, wind outflow falls sharply, and turbulence from magnetorotational instability and convection takes over the inward decrease.

Catalog record

CREATORMu-Qing Liu, Xiao-Hong Yang, De-Fu Bu
YEAR2026
COLLECTIONPAPERS
FORMATTXT
FILE SIZE67320
LICENSEhttp://creativecommons.org/licenses/by/4.0/
RIGHTSCC BY
SOURCEarXiv

Source: https://arxiv.org/abs/2604.13762

Browse the full library · About the Tower of Babel

Full text

The opening of the work, from the library's hosted text:

Radiative cooling effects on black hole hot accretion flows around the sub-Bondi radius Mu-Qing Liu, Xiao-Hong Yang, De-Fu Bu Abstract Aims. It is difficult to implement numerical simulations on a region extending from the vicinity of a black hole to the Bondi radius. Most previous numerical simulations have primarily concentrated on the region close to the black hole. They found that strong winds can be generated in the hot accretion flows near the black hole, and that radiative cooling significantly affects the strength of these winds. However, the effects of radiative cooling on the production and properties of winds around the Bondi radius remain unclear. Methods. In this paper, we perform two-dimensional magnetohydrodynamic simulations to study the impact of radiative cooling on the dynamics and wind production in hot accretion flows around the sub-Bondi radius. Results. As the increase of mass accretion rate, radiative cooling gradually becomes strong, resulting in a reduction in the thickness of the accretion disk (defined as the accretion flows within the density scale height). Based on the Høiland criterion, we find that within the accretion disk, the region of convective stability accounts for ∼ \sim 55–62 %, and therefore the accretion flows are marginally stable in convective stability. In the runs with weak radiative cooling, the winds play a significant role in the inward decrease of the mass inflow rate. In the runs with strong radiative cooling, the mass outflow rate of winds is significantly reduced and then the inward decrease of the mass inflow rate is mainly attributed to turbulence driven by magnetorotational instability and convection. Radiative cooling has the potential to suppress accretion processes and reduce the power of winds. 1 Introduction Supermassive black holes (SMBHs) are widely believed to exist at the centers of galaxies. In nearby galaxies, most of active galactic nuclei (AGNs) are low-luminosity AGNs (LLAGNs) with luminosities ranging from 10^{-9} to 10^{-1}L_{\rm Edd} , where L_{\rm Edd} is the Eddington luminosity ( 24 ; 25 ) . Hot accretion flows around SMBHs are generally employed to explain the observed properties of LLAGNs. Hot accretion flows are characterized by lower density and higher temperature, which causes them to be radiatively inefficient. The energy dissipated in hot accretion flows is advected into SMBHs along with the accreting matter. These flows are commonly referred to as advection-dominated accretion flows (ADAFs, 26 ; 46 ; 42 ; 43 ; 1 ). In recent years, a series of numerical studies have investigated the hot accretion flows in detail ( 48 ; 27 ; 28 ; 19 ; 49 ; 20 ; 54 ) . One of the significant findings is the identification of strong winds launched from the radiatively-inefficient hot accretion flows ( 54 ; 55 ) . 48 implemented the two-dimensional hydrodynamic (HD) simulations of non-radiative hot accretion flows and found that the mass inflow rate diminishes as the radius decreases. 54 confirmed that the wind-induced mass loss results in a reduction of the mass inflow rate as the accretion gas moves inward. Based on observations from the Chandra X-ray Observatory, 52 confirmed the existence of winds originating from hot accretion flows surrounding the SMBH in our galactic center (Sgr A ∗ ). For further investigating the properties of winds, 55 performed the trajectory analysis of the virtual Lagrangian particles based on a 3D general relativistic magnetohydrodynamic (MHD) simulation of non-radiative hot accretion flows around a Schwarzschild BH. They found that, at small scale ( r<10^{3}r_{\rm s} , with r_{\rm s} being Schwarzschild radius), the radial profile of the mass flux of winds can be approximately expressed as \dot{M}_{\rm wind}\approx\dot{M}_{\rm BH}(r/20r_{\rm s}) , where \dot{M}_{\rm BH} is the mass accretion rate at the BH horizon. This result suggests that most of the winds are produced at large radii within the region of r<10^{3}r_{\rm s} . When radiative cooling is considered, the strength of winds depends on the accretion rate ( 9 ) . Based on the 2D HD simulations, 9 found that radiative cooling becomes important with the increase of accretion rate. When the accretion rate increases to a value, winds become very weak. Their study did not consider the effect of magnetic field. However, if magnetic field is taken into account, the wind strength may be changed due to the presence of the magnetic-driving winds ( 7 ; 12 ; 36 ) . The aforementioned studies primarily investigate the generation of winds on small scales ( r<10^{3}r_{\rm s} ), i.e. on the region close to the BH. Therefore, the important questions are whether or not the winds can be produced at large scale ( r>10^{3}r_{\rm s} ) and how the accretion rate influences the wind strength. The accretion processes around a BH are generally believed to extend out to the Bondi radius ( 8 ) . For the spherically symmetric flow without rotation and radiation, within the Bondi radius, the gas is gravitationally bound. For a realistic accretion flow, due to the presence of gas angular momentum and radiative cooling, the accretion flow can not be adequately described by the Bondi solution. A dynamical range extending from the Bondi radius to the vicinity of a BH is excessively large. It is difficult to implement numerical simulation on this dynamical range. A feasible approach is to independently implement numerical simulations at small scales (the vicinity of a BH) and large scales (near the Bondi radius) to investigate the dynamics of accretion flows. Several previous works have implemented HD and MHD simulations to study the hot accretion flows at large scales ( 35 ; 10 ; 11 ; 30 ; 29 ; 39 ) . 10 ; 11 and 30 studied the radiatively-inefficient accretion flows around the sub-Bondi radius. 35 implemented HD simulations to study the effect of radiative cooling on the accretion flows around the sub-Bondi radius. They found that strong radiative cooling promotes accretion. In the HD simulations, the \alpha -viscosity prescription is usually employed to mimic the anomalous shear stresses for angular momentum transport and the heating effects resulting from the work done by stresses. However, HD simulation results depends on the assumption of \alpha . In reality, the transport of angular momentum in accretion flows should be driven by Maxwell stresses arising from MHD turbulence, which is induced by the magnetorotational instability (MRI; 3 ). Therefore, it is necessary to perform MHD simulations on the accretion flows around the Bondi radius. In this paper, we perform MHD simulations to investigate the effects of radiative cooling on the dynamics and wind production in hot accretion flows around the sub-Bondi radius. In Section 2, we will describe the method and model setup. In Section 3, we will will analyze the main results. In Sections 4 and 5, we will present a discussion and a summary of the results, respectively. 2 Method 2.1 Basic equations and numerical method To describe the BH hot accretion flows around the sub-Bondi radius, we employ the MHD equations as follows: \frac{\partial\rho}{\partial t}+\nabla\cdot{(\rho\bm{v})}=0, (1) \frac{\partial(\rho\bm{v})}{\partial t}+\nabla\cdot{[\rho\bm{v}\bm{v}-\bm{B}\bm{B}+(p_{\rm g}+\frac{\bm{B}^{2}}{2})]}=-\rho\nabla{\Psi}, (2) \frac{\partial E_{\rm t}}{\partial t}+\nabla\cdot{[(E_{\rm t}+p_{\rm g})\bm{v}-\bm{B}(\bm{v}\cdot\bm{B})]}=-\rho\bm{v}\cdot\nabla\Psi-Q^{-}_{\rm brem}, (3) \frac{\partial\bm{B}}{\partial t}-\nabla\times{(\bm{v}\times\bm{B})}=0. (4) Here, \rho , p_{\rm g} , \bm{v} , and \bm{B} 1 1 1 A factor of 1/\sqrt{4\pi} has been absorbed. are the density, pressure, velocity, and magnetic field, respectively.

Read the complete text