High-efficiency Electro-Optic Lens for radio frequency beam wavefront modulation for mode mismatch sensing

Liu Tao, Mauricio Diaz-Ortiz, Paul Fulda · 2025

Read High-efficiency Electro-Optic Lens for radio frequency beam wavefront modulation for mode mismatch sensing by Liu Tao, Mauricio Diaz-Ortiz, Paul Fulda (2025) in the Tower of Babel, a free online library of public-domain works preserved in clean, searchable text. No sign-up. The full text is served as a plain-text file at a predictable URL, where text is present: https://antarctic-labs.com/tower-of-babel/arxiv-2502-13885.txt.

Introduction

Liu Tao, Mauricio Diaz-Ortiz, and Paul Fulda demonstrate a lens that can bend a laser beam's wavefront on command, for use in gravitational wave detectors, in this 2025 paper. When the beam shape in a detector's cavities drifts from the ideal, sensitivity falls. A sensor for that mismatch needs a way to wobble the wavefront at radio frequencies and read the response.

Their electro-optic lens does the wobbling, and a special telescope reshapes the sidebands so the mismatch signal does not cancel itself out. The authors work through the math and run simulations of how much sideband power the actuation creates. Beam size at the crystal's edges trades against clipping loss, and they turn that trade into design rules. The result is a practical guide for building efficient versions of the device.

Catalog record

CREATORLiu Tao, Mauricio Diaz-Ortiz, Paul Fulda
YEAR2025
COLLECTIONPAPERS
FORMATTXT
FILE SIZE38 KB
VERSION1.0
LICENSEhttp://creativecommons.org/licenses/by/4.0/
RIGHTSCC BY
SOURCEarXiv

Source: https://arxiv.org/abs/2502-13885

Browse the full library · About the Tower of Babel

Full text

The opening of the work, from the library's hosted text:

High-efficiency Electro-Optic Lens for radio frequency beam wavefront modulation for mode mismatch sensing Liu Tao, Mauricio Diaz-Ortiz, Paul Fulda Abstract Active mode mismatch sensing and control can facilitate optimal coupling in optical cavity experiments such as interferometric gravitational wave detectors. In this paper, we demonstrate a radio-frequency (RF) beam wavefront curvature modulation-based mode mismatch sensing scheme inspired by the previously proposed RF beam jitter alignment sensing scheme. The proposed mode mismatch sensing scheme uses an electro-optic lens (EOL) device that is designed to provide the required beam wavefront curvature actuation, as well as a mode converting telescope that rephases the RF second-order modes and generates a non-vanishing mode mismatch sensing signal. We carefully investigate the total second-order mode generation from the wavefront actuation both analytically and numerically, taking the effects of Gaussian beam size evolution and the second-order mode phase mismatch cancellation into consideration. We demonstrate the second-order mode generation as a function of the incident beam waist size and the electro-optic crystal size, which along with a “trade-off” consideration of the beam size at the edges of the crystal and the clipping loss, provides us with guidance for designing the beam profile that interacts with the crystal to improve the EOL modulation efficiency. I Introduction Precise locking and control of perfect alignment and mode-matching states are essential for maintaining efficient power coupling of laser beams to spherical optical resonators in many high-precision optical cavity experiments, such as in searches for particles beyond the standard model [ 1 ] and precision measurements of quantum gravity phenomena at the Planck scale [ 2 , 3 ] . This requires, for instance, that the laser beam wavefront curvature must match the curvature of the cavity mirrors at their positions on the optical axis to achieve optimal resonance in the optical cavity. Imperfect matching of the eigenmode of an optical cavity and an injected laser beam mode leads to degradations in optical resonance and power coupling for the laser beam [ 4 , 5 , 6 ] . High-finesse optical cavities are also widely used in applications related to gravitational wave detection. Monitoring and correcting the mode-matching state is becoming increasingly important for advanced Gravitational Wave (GW) detectors such as Advanced LIGO and Advanced Virgo [ 7 , 8 ] , which are mostly composed of multiple inter-coupled suspended cavities, to yield the optimal sensitivity. For instance, it was demonstrated that the coupling of injected squeezed light in advanced GW detectors to the main interferometer can be extremely sensitive to mode mismatch losses [ 9 , 10 , 11 , 12 ] . In addition, the power loss scattered into the second-order modes by a mode mismatch between the laser beam and the output mode cleaner cavity in aLIGO also directly corresponds to a loss of GW signal and an increased shot noise level at the GW readout. One should ideally monitor and limit the amount of mode mismatch to prevent the degradation of squeezing performance and of the sensitivity of GW detectors. Several hardware and schemes for sensing and correcting mode mismatches have been proposed. For instance, radio-frequency (RF) quadrant photodiodes or bullseye photodiodes have been proposed and demonstrated for sensing and controlling the beam wavefront distortion, with the use of multiple sensors and Gouy phase telescopes for the complete mode mismatch degrees of freedom (DoFs), such as the beam waist size and waist position mismatch [ 13 , 14 ] . An alternative novel method through the generation of RF higher-order mode sidebands has also been proposed for determining and correcting the alignment and mode matching states of the laser mode coupling to the eigenmode of optical cavities [ 15 , 16 ] . These RF beam modulation-based sensing schemes have potential advantages over the traditional standard schemes by greatly simplifying the experiment with the use of a single-element photodiode for the complete sensing of all DoFs and do not require any additional Gouy phase telescopes. In this paper, we extend the RF beam jitter alignment sensing scheme proposed by P. Fulda et al. [ 15 ] , to characterize and correct mode mismatches between laser beam mode and the eigenmodes of optical cavities. This QPD-free mode mismatch sensing scheme uses an electro-optic lens (EOL) device as a fast wavefront curvature actuator that provides the required RF beam wavefront curvature modulation [ 15 , 17 , 18 , 19 ] . Second-order spatial mode RF sidebands are generated at twice the mode separation frequency of an optical cavity. This guarantees the co-resonance in the cavity of one of the second-order mode sidebands with the carrier light in the fundamental mode. Complete RF lens (RFL) mode mismatch sensing signals can theoretically be obtained through the detection of the beat signal between the second-order mode RF sidebands from the wavefront modulation with the second-order mode carrier field from the static mode mismatch with only a single-element photodiode for both mode mismatch DoFs, at orthogonal demodulation phases, as described in our previous work [ 18 ] . In this paper, we propose a design and demonstrate by simulation our implementation of the electro-optic lens device, by sandwiching an electro-optic crystal between three pairs of alternating polarity electrodes. We will calculate the change in the refractive index of the crystal near the central axial region due to the Pockels electro-optic effect, and thus the accumulated phase map for the input Gaussian beam coupling, and show that it can be well approximated by a hyperbolic paraboloid surface. The interaction of the Gaussian beam with the hyperbolic paraboloidal phase map is characterized in terms of scattering in the Hermite-Gaussian (HG) mode basis through numerical mode decomposition technique. The phase of the second-order scattered modes \mathrm{HG}_{2,0} and \mathrm{HG}_{0,2} differ by \pi due to the opposite signs for the focal length from the phase profile in the two principal transverse directions, which leads to vanishing RFL mode mismatch sensing signals. The hyperbolic paraboloid phase profile, and thus the phase difference between the second-order modes, can however be corrected by passing the beam through a subsequent astigmatic mode converter. This rephases the second-order modes in the RF wavefront modulation sidebands, producing the desired second-order Laguerre-Gauss \mathrm{LG_{1,0}} mode for the RFL sensing. The strength of the RFL mode mismatch sensing signals depends on the effective modulation depth, namely the amount of second-order modes in the RF beam wavefront curvature modulation sidebands as the Gaussian input beam interacts with the electro-optic crystal inside the EOL. On the other hand, the size and the wavefront curvature of the input beam vary as it propagates inside the crystal. This changes the amplitude and the phase of the RF modulation second-order modes. The phase mismatch between the second-order modes generated at different locations in the crystal leads to cancellation and a reduction in the total RF second-order mode generation. This cancellation of the RF second-order modes due to the phase mismatch is carefully calculated analytically in this paper. The result is verified with corresponding numerical results by treating the input Gaussian beam amplitude profile and the paraboloidal phase maps as two-dimensional arrays. This more careful and precise treatment gives us a significant difference in the estimation of the total RF second-order mode generation compared to

Read the complete text