Power Amplifier-Aware Transmit Power Optimization for OFDM and SC-FDMA Systems
Pawel KRYSZKIEWICZ · 2025
Read Power Amplifier-Aware Transmit Power Optimization for OFDM and SC-FDMA Systems by Pawel KRYSZKIEWICZ (2025) in the Tower of Babel, a free online library of public-domain works preserved in clean, searchable text. No sign-up. The full text is served as a plain-text file at a predictable URL, where text is present: https://antarctic-labs.com/tower-of-babel/arxiv-2501-11994.txt.
Introduction
Kryszkiewicz optimises transmit power in mobile systems while accounting for amplifier distortion in twenty twenty-five. Phones use SC-FDMA on the uplink because its signal envelope fluctuates less than OFDM. Gentler signals let amplifiers run more efficiently. Quality is usually guarded by a transmitter side error limit.
His approach models the nonlinear amplifier directly in the optimisation. The goal becomes the best signal to noise and distortion ratio at the receiver. An analytic model covers OFDM, and a semi analytic one covers SC-FDMA. Simulations show better receiver quality for both schemes. SC-FDMA still wins overall. The author argues amplifier aware design can boost performance and sustainability in next generation networks.
Catalog record
| CREATOR | Pawel KRYSZKIEWICZ |
|---|---|
| YEAR | 2025 |
| COLLECTION | PAPERS |
| FORMAT | TXT |
| FILE SIZE | 26 KB |
| VERSION | 1.0 |
| LICENSE | http://creativecommons.org/licenses/by/4.0/ |
| RIGHTS | CC BY |
| SOURCE | arXiv |
Source: https://arxiv.org/abs/2501-11994
Browse the full library · About the Tower of Babel
Full text
The opening of the work, from the library's hosted text:
Power Amplifier-Aware Transmit Power Optimization for OFDM and SC-FDMA Systems Thanks: This research was funded by the Polish National Science Centre, project no. 2021/41/B/ST7/00136. For the purpose of Open Access, the author has applied a CC-BY public copyright license to any Author Accepted Manuscript (AAM) version arising from this submission. Pawel KRYSZKIEWICZ Abstract The Single Carrier-Frequency Division Multiple Access (SC-FDMA) is a transmission technique used in the uplink of Long Term Evolution (LTE) and 5G systems, as it is characterized by reduced transmitted signal envelope fluctuations in comparison to Orthogonal Frequency Division Multiplexing (OFDM) technique used in the downlink. This allows for higher energy efficiency of User Equipments (UEs) while maintaining sufficient signal quality, measured by Error Vector Magnitude (EVM), at the transmitter. This paper proposes to model a nonlinear Power Amplifier (PA) influence while optimizing the transmit power in order to maximize the Signal to Noise and Distortion power Ratio (SNDR) at the receiver, removing the transmitter-based EVM constraint. An analytic model of SNDR for the OFDM system and a semi-analytical model for the SC-FDMA system are provided. Numerical investigations show that the proposed transmit power optimization allows for improved signal quality at the receiver for both OFDM and SC-FDMA systems. However, SC-FDMA still outperforms OFDM in this matter. Such a power amplifier-aware wireless transmitter optimization should be considered to boost the performance and sustainability of next-generation wireless systems, including Internet of Things (IoT) ones. I Introduction One of the important challenges for future wireless communication systems is to improve their sustainability. It is the most important for Internet of Things (IoT) devices that are typically battery-powered and require their energy efficiency to be high. One of the solutions, utilized, e.g., in User Equipments (UEs) of LTE or 5G New Radio (NR) systems, is Single Carrier-Frequency Division Multiple Access (SC-FDMA), called also Discrete Fourier Transform (DFT)-precoded Orthogonal Frequency Division Multiplexing (OFDM) [ 1 ] . This allows to reduce complex envelope signal fluctuations, typically measured by Peak-to-Average Power Ratio (PAPR), in comparison to an OFDM signal. The higher the envelope fluctuations the higher the amount of nonlinear distortion while passing through a nonlinear Power Amplifier (PA) [ 2 ] . Additionally, SC-FDMA can result in lower energy consumption by the PA [ 3 ] . Contemporary, the nonlinear distortion is limited to comply with some performance metric at the transmitter, e.g., Error Vector Magnitude (EVM) [ 4 , 5 ] . This can be achieved, e.g., by fixing the PA operating point, i.e., transmission power in relation to the clipping power of the PA. However, recently it has been observed for OFDM systems that it is possible to adjust the operating point in order to maximize the transmission quality [ 6 ] , i.e., find balance between wanted signal power and nonlinear distortion power from the perspective of receiver-observed Signal to Noise and Distortion power Ratio (SNDR). The authors utilized a soft-limiter (clipper) PA model, that because of its simplicity, allowed for an analytic solution. Next, in [ 7 ] this concept has been extended to an OFDM system utilized in an edge computing scenario. The Rapp model, being a more generalized solution to a PA modeling, was used in [ 3 ] , though a closed-form expression was not obtained. Moreover, in addition to SNDR calculation energy efficiency maximization for OFDM was considered. The main conclusion of these papers is that dynamic operating point adjustment allows for higher throughput or even any transmission in a long-range link scenario. However, similar considerations are missing for SC-FDMA systems, more suitable for uplink or IoT transmissions. For this purpose, SC-FDMA amplitude distribution is needed. Its approximation requiring though numerical integration is provided in [ 1 ] . It has been used in [ 8 ] to perform EVM analysis at the receiver for an SC-FDMA and OFDM transmission. To obtain results some data, e.g., SC-FDMA Power Spectral density (PSD) was obtained using simulations. As such the authors call their model semi-analytic. However, dynamic operating point adjustment has not been considered therein. This paper aims to derive the average SNDR formula for OFDM and SC-FDMA under soft-limiter PA to compare their performance under dynamic operating point adjustment. While OFDM allows for an analytic formula, a semi-analytic solution is provided for SC-FDMA with a theoretical justification of factors impacting SNDR. Moreover, while typically, time-domain SNDR calculation is used, e.g., in [ 6 , 3 ] , here a more accurate frequency-domain SNDR definition is provided, considering only in-band distortion. The numerical analysis is carried out showing that, similarly as in OFDM, dynamic operating point adjustment can significantly improve received signal quality for the SC-FDMA technique, though the optimal operating point depends on the constellation size and is different than for the OFDM. Moreover, the in-band-only distortion calculation is shown to result in a different operating point than the time-domain method and as such should be used. The paper is organized as follows: The system model along with SNDR definitions for OFDM and SC-FDMA systems are shown in Sec. II . Next, the optimization problem for finding the SNDR maximizing operating point is shown in Sec. III . The numerical evaluation results are shown in Sec. IV that is followed by conclusions in Sec. V . II System Model The considered transmitter is composed of an N -point Inverse Fast Fourier Transform (IFFT) block with the n -th sample of a single SC-FDMA/OFDM symbol on its output described as x_{n}=\sum_{k=0}^{N_{U}-1}d_{k}e^{j2\pi\frac{nI_{k}}{N}}, (1) where d_{k} is the complex symbol modulating I_{k} -th subcarrier. The indices of all N_{U} occupied subcarriers are denoted by a vector I composed of unique, increasing (sorted in ascending order) elements of a total set of available subcarriers \{-N/2,....,N/2-1\} . In general, there is no assumption regarding the utilized subcarriers location, e.g., [ 1 ] shown that the transmitted signal amplitude distribution, used in derivations in this paper, is invariant of the subcarriers allocation scheme. However, the performed simulations follow the Localized Frequency Division Multiple Access (LFDMA) approach, i.e., all utilized subcarriers are in a single block, similarly as in [ 8 ] . The unoccupied subcarriers are left to allow for digital-analog processing (reducing aliasing effect) or in order to reduce interference to other users. For OFDM the modulating symbols d_{k} belong to one of the Quadrature Amplitude Modulation (QAM) or Phase Shift Keying (PSK) constellations. However, for a SC-FDMA waveform the symbols d_{k} are obtained as a result of N_{U} -point DFT processing as d_{k}=\frac{1}{\sqrt{N_{U}}}\sum_{\tilde{n}=0}^{N_{U}-1}\tilde{d}_{\tilde{n}}e^{-j2\pi\frac{\tilde{n}k}{N}}, (2) for k\in\{0,...,N_{U}-1\} . Here we assume \tilde{d}_{\tilde{n}} are independent, complex symbols belonging to a chosen QAM/PSK constellation. Both for OFDM and SC-FDMA the transmitted time-domain signal has fixed mean power \mathbb{E}\left[|x_{n}|^{2}\right]=\sigma^{2}. (3) Such a signal passes through a nonlinear PA of transfer function \Gamma(~) giving output sample y_{n} as y_{n}=\Gamma\left(x_{n}\right). (4) While there are multiple PA models [ 2 ] , here a soft-limiter will be used. First, it provides the highest, out of all possible nonlinearities, Signal to Distortion Ratio (SDR) in the case of OFDM signal [ 9 ] . It is also possible that such a characteristic is obtained as an effective one for a PA preceded by a predistorter [ 10 ] . Moreover, in the case of a soft-limiter