Pion and kaon pair production in double gap events in ALICE Run 3

Rainer Schicker, for the ALICE Collaboration · 2024

Read Pion and kaon pair production in double gap events in ALICE Run 3 by Rainer Schicker, for the ALICE Collaboration (2024) in the Tower of Babel, a free online library of public-domain works preserved in clean, searchable text. No sign-up. The full text is served as a plain-text file at a predictable URL, where text is present: https://antarctic-labs.com/tower-of-babel/arxiv-2412-08452.txt.

Introduction

Rainer Schicker reports on pion and kaon pair production in double gap events at ALICE in a 2024 conference paper for the collaboration. ALICE is a detector at the Large Hadron Collider. It received a major upgrade during a long shutdown. The upgrade allows much higher data rates in recent runs. The paper describes upgrades to systems used for double gap events. In such events, two empty regions flank the produced particles. It also presents the improved data taking capability for those events.

Catalog record

CREATORRainer Schicker, for the ALICE Collaboration
YEAR2024
COLLECTIONPAPERS
FORMATTXT
FILE SIZE12 KB
VERSION1.0
LICENSEhttp://creativecommons.org/licenses/by/4.0/
RIGHTSCC BY
SOURCEarXiv

Source: https://arxiv.org/abs/2412-08452

Browse the full library · About the Tower of Babel

Full text

The opening of the work, from the library's hosted text:

Pion and kaon pair production in double gap events in ALICE Run 3 Thanks: Presented at “Diffraction and Low- x x 2024”, Trabia (Palermo, Italy), September 8-14, 2024. Rainer Schicker, for the ALICE Collaboration Abstract The ALICE detector at the LHC has undergone a major upgrade in the long shutdown 2019-2021 to be able to take data at much-increased rates in Runs 3 and 4. The upgrades of the detector systems used for analysing double gap events are described, and the improvement in data taking capability for such double gap events is presented. 1 Introduction In the long shutdown LS2 of 2019-2021, the ALICE experiment at the LHC was upgraded in order to take data at much-increased rates in Runs 3 (2022-2025) and 4 (2029-2032) [ 1 ] . The readout was changed to continuous mode, with data collected in proton-proton collisions at rates up to 650 kHz, and subsequently being processed to identify the events of interest. The selected events are permanently stored for future processing. All data taken in heavy-ion collisions at up to 50 kHz are permanently stored, and available for later analysis. 2 The detector upgrades The Time-Projection-Chamber (TPC) is not only the main tracking detector of the ALICE experiment but also provides information on the specific ionisation energy loss dE/dx for particle identification. The ionisation electrons drift in the electric field of 400 V/cm to the endplates of the cylindrical field cage. The ionisation charges were amplified in Runs 1 (2009-2013) and 2 (2015-2018) by multiwire proportional chambers (MWPCs), with the backflow of positive ions controlled by gating grids. The effective rate was limited in Runs 1 and 2 to about 1 kHz for Pb-Pb and about 3 kHz for pp collisions. In order to increase the rate capability to about 50 kHz in Pb-Pb, the MWPCs were replaced by chambers with a stack of 4 Gas Electron Multipliers (GEMs) with continuous readout and synchronous data processing [ 2 ] . In Runs 1 and 2, the readout rate of the Inner Tracking System (ITS) was limited to 1 kHz. The new ITS system implemented for Run 3 features improved resolution, less material and faster readout. The new system consists of 7 layers of Monolithic Active Pixel Sensors, with a spatial resolution (r \phi x z) improved from (11 x 100) \mu m 2 of the old ITS to (5 x 5) \mu m 2 . The readout rate of this new ITS system is 100 kHz in Pb-Pb [ 3 ] . With these TPC and ITS upgrades, data have been taken so far in pp collisions at rates up to 650 kHz, and tests for rates up to 1 MHz are planned. Outside of the central barrel pseudorapidity range |\eta|< 0.9, a Fast Interaction Trigger (FIT) system was built for Run 3 to provide precise collision time information for time-of-flight-based particle information, for online luminosity monitoring and measuring forward multiplicity [ 4 ] . This FIT system consists of the following detectors: • FT0: Two Cherenkov arrays for minimum bias triggering, for determining the collision time and for vertex position calculation. • FV0: A large scintillator array consisting of five rings and eight sectors is positioned on the opposite side of the ALICE muon spectrometer. In conjunction with FT0, it is used for centrality and event plane determination in heavy-ion collisions. • FDD (Forward Diffractive Detector): This double-sided scintillator array is essential for tagging diffractive events by establishing rapidity gaps in the event. Detector \eta_{min} \eta_{max} z [cm] FDD-A 4.8 6.3 1696.0 FT0-A 3.5 4.9 334.6 FV0 2.2 5.1 320.8 FT0-C -3.3 -2.1 -84.3 FDD-C -7.0 -4.9 -1956.6 Table 1: The pseudorapidity range and the z-position of the FIT subsystems. The parameters of the different FIT subsystems are shown in Table 1 . Events with particle production measured in the ALICE central barrel and absence of signals in the FIT systems are tagged as double gap events. 3 The computing system upgrade After the upgrade of the ALICE detector systems in LS2, the raw data flow to the data acquisition system increased a hundredfold, up to 3.5 TB/s. A new Online/Offline Computing system, O 2 , was developed to cope with this challenge [ 5 ] . The O 2 system incorporates continuous readout of most subdetectors, data compression using partial synchronous reconstruction and calibration, and the sharing of common computing resources during and for asynchronous reconstruction after data taking. The reconstructed data are written to disk while the raw data are discarded. The O 2 architecture consists of two major computing layers, the First Level Processors (FLPs) and the Event Processing Nodes (EPNs). Both layers are highly heterogeneous, with specialized acquisition cards embedding FPGAs on the FLPs, and GPUs on the EPNs. The raw data rate of 3.5 TB/s is reduced by the FLP layer to \sim 635 GB/s and by the EPN layer to 100 GB/s. This compressed data stream is stored and, after later asynchronous processing, distributed to the Tier 0 and Tier 1 analysis facilities. \begin{overpic}[r-int-lumi-2022-2024-1.pdf] \put(127.8,94.0){\color[rgb]{1,0.37,1}\vector{-1}{0}{12.0}} \put(127.8,94.0){\color[rgb]{1,0.37,1}\vector{1}{0}{12.0}} \par\par\put(181.0,43.0){\color[rgb]{1,0,0}\vector{-1}{0}{12.0}} \put(181.0,43.0){\color[rgb]{1,0,0}\vector{1}{0}{12.0}} \par\par\par\put(140.4,128.0){\color[rgb]{1,0.37,1}\vector{0}{1}{33.4}} \put(140.4,128.0){\color[rgb]{1,0.37,1}\vector{0}{-1}{33.4}} \par\put(192.8,64.0){\color[rgb]{1,0,0}\vector{0}{1}{20.0}} \put(192.8,64.0){\color[rgb]{1,0,0}\vector{0}{-1}{20.0}} \par\put(114.0,85.0){\scriptsize{\color[rgb]{1,0.37,1}$\!\sim\!$ 6 $\!$wks}} \par\put(168.0,33.0){\scriptsize{\color[rgb]{1,0,0}$\!\sim\!$ 6 $\!$wks}} \par\put(144.0,112.0){\rotatebox{90.0}{\scriptsize{\color[rgb]{1,0.37,1}$\!\sim\!$ 16 $\!$pb${}^{\!-\!1}$}}} \par\put(196.0,46.0){\rotatebox{90.0}{\scriptsize{\color[rgb]{1,0,0} $\!\sim\!$ 10 $\!$pb${}^{\!-\!1}$}}} \par\put(167.0,61.0){\rotatebox{64.0}{\scriptsize{\color[rgb]{1,0,0}2022}}} \put(114.0,120.0){\rotatebox{70.0}{\scriptsize{\color[rgb]{1,0.37,1}2024}}} \par\par\end{overpic} Figure 1: The Run 3 ALICE data sample amounts to about 10 pb -1 per 6 weeks of data taking in 2022, and to about 16 pb -1 per 6 weeks in 2024. This upgrade of the ALICE experiment resulted in a considerably increased data taking capability. The double gap data sample collected in Run 2 amounts to about 10 pb -1 . As shown in Fig. 1 , the ALICE data sample was about 10 pb -1 per 6 weeks of data taking in 2022, and about 16 pb -1 per 6 weeks of data taking in 2024. 4 Central diffractive production at the LHC Central diffractive events are characterized by particle production at midrapidity, and by rapidity gaps up to the rapidity of the beam particle or its remnants. The ALICE experiment is ideally suited for studying such events due to the excellent global tracking in the central barrel by the combined information of TPC and ITS and the superb particle identification of the TPC. The absence of particles at forward/backward rapidities can be established by requiring no signals in the FIT detector systems. In the following, only events with two particles at midrapidity are shown. \begin{overpic}[dg_pions_2d_mass_vs_pt_appr.pdf] \end{overpic} \begin{overpic}[dg_pions_1d_mass_vs_nev_appr.pdf] \put(62.4,28.0){\rotatebox{90.0}{\hbox{\pagecolor{White}\pic@makebox@{\makebox}{}(16.0,1.0){\tiny{$\rho$(770)}}}}} \put(73.2,26.0){\rotatebox{90.0}{\hbox{\pagecolor{White}\pic@makebox@{\makebox}{}(18.0,1.0){\tiny{$f_{0}$(980)}}}}} \put(86.6,22.0){\rotatebox{90.0}{\hbox{\pagecolor{White}\pic@makebox@{\makebox}{}(21.0,1.0){\tiny{$f_{2}$(1270)}}}}} \end{overpic} Figure 2: Transverse momentum vs. invariant mass of unlike-sign pion pairs on the left, invariant mass distribution for like and unlike-sign pion pairs on the right. In Fig. 2 on the left, the transverse momentum p_{\rm T} of unlike-sign pion pairs is shown vs. the pair mass M_{\pi\pi} , reflecting the ALICE pair acceptance. Integrating this distribution over the pair p_{\rm T} yields the pion pair invariant mass distribution shown on the right of Fig. 2 . The corresponding distributions of kaon pairs are shown in Fig. 3 . Figure 3: Transverse momentum vs. invariant mass of unlike-sign kaon pairs on the left, invariant mass distribution for like and unlike-sign kaon pairs on the right. The invariant pair mass spectra in both the pion and kaon sectors shown in Figs. 2 and 3 exhibit

Read the complete text